数控车床外圆车凹圆弧怎样编程实心的?

数控车床外圆车凹圆弧怎样编程实心的?

列如:螺纹30*2 外圆以车到30,牙长:30螺纹切削循环指令:G92程序如下:牙距要乘1.3,就是2.6所以30-2.6=27.4,每刀分别以30丝,20丝,10丝进车,车时,外圆最好负20丝~30丝,孔螺纹要加,外圆要减(27.4)G0 X32 Z2G92 X29.6 Z-29.5 F2X29.3X29X28.7X28.4X28.2X28X27.8X27.6X27.5X27.4X27.4G0 Z6G0 X200 Z200M30

请教下数控车床车五角星或者爱心车法?

刚想到的,改变起刀点的端面螺纹,还没有实践,我也是第一次听说车五星G97 S20 M03 T0909G0X35Z0M98P1001L150G0X35Z0M98P1002L150G0X35Z0M98P1003L150G0X35Z0M98P1004L150G0X35Z0M98P1005L150M30O1001G01 W-0.02 G32 U-30.F150G32U30.2F150G04X2.M99O1002G01 W-0.02 G32 U-30. Q72 F150G32U30.2F150G04X2.M99O1003G01 W-0.02 G32 U-30。Q144F150G32U30.2F150G04X2.M99O1004G01 W-0.02 G32 U-30.Q216F150G32U30.2F150G04X2.M99O1005G01 W-0.02 G32 U-30.Q288F150G32U30.2F150G04X2.M99

原创不易,转载请注明源于noorgioielli.com网~~

原文地址:数控车床外圆车凹圆弧怎样编程实心的?发布于2022-05-21 14:21:32